K0FTT Automobiles

My position About ☰

reset

S51ZK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S51ZK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1759994189	94 Count	1025 Count	82 Count
1759990586	84 Count	906 Count	73 Count
1759986983	79 Count	834 Count	69 Count
1759983398	73 Count	757 Count	64 Count
1759979795	66 Count	693 Count	58 Count
1759976191	57 Count	610 Count	50 Count
1759972588	50 Count	532 Count	44 Count
1759968985	43 Count	461 Count	38 Count
1759965382	36 Count	392 Count	32 Count
1759961797	27 Count	317 Count	24 Count
1759958194	20 Count	231 Count	18 Count
1759954591	13 Count	156 Count	12 Count
1759950988	6 Count	73 Count	6 Count
1759947384	91 Count	1030 Count	78 Count
1759943781	84 Count	956 Count	72 Count
1759940196	77 Count	872 Count	66 Count
1759936593	70 Count	806 Count	60 Count
1759932990	62 Count	741 Count	53 Count
1759929387	56 Count	680 Count	48 Count
1759925784	49 Count	617 Count	42 Count
1759922180	42 Count	564 Count	36 Count
1759918596	35 Count	489 Count	30 Count
1759914993	28 Count	387 Count	24 Count
1759911390	21 Count	253 Count	18 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)