K0FTT Automobiles

My position About ☰

reset

SP2SGK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765983434	934 Count	782 Count	505 Count
1765982531	932 Count	780 Count	504 Count
1765981628	930 Count	778 Count	503 Count
1765980725	928 Count	776 Count	502 Count
1765979822	926 Count	774 Count	501 Count
1765978919	924 Count	772 Count	500 Count
1765978016	922 Count	770 Count	499 Count
1765977113	920 Count	768 Count	498 Count
1765976210	918 Count	766 Count	497 Count
1765975307	917 Count	765 Count	497 Count
1765974404	915 Count	763 Count	496 Count
1765973501	913 Count	761 Count	495 Count
1765972599	910 Count	758 Count	493 Count
1765971696	908 Count	756 Count	492 Count
1765970793	906 Count	754 Count	491 Count
1765969890	904 Count	752 Count	490 Count
1765968084	900 Count	749 Count	488 Count
1765967181	898 Count	747 Count	487 Count
1765966346	896 Count	745 Count	486 Count
1765965443	894 Count	743 Count	485 Count
1765964540	892 Count	741 Count	484 Count
1765963637	890 Count	739 Count	483 Count
1765962734	888 Count	737 Count	482 Count
1765961831	886 Count	735 Count	481 Count
1765960928	884 Count	733 Count	480 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)