K0FTT Automobiles

My position About ☰

reset

M7PDA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M7PDA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1750028555	233 Count	229 Count	154 Count
1750026752	230 Count	226 Count	152 Count
1750024949	227 Count	223 Count	150 Count
1750023182	224 Count	220 Count	148 Count
1750021379	221 Count	217 Count	146 Count
1750019580	218 Count	214 Count	144 Count
1750017773	215 Count	211 Count	142 Count
1750015970	212 Count	208 Count	140 Count
1750014167	209 Count	205 Count	138 Count
1750012364	206 Count	202 Count	136 Count
1750010561	201 Count	197 Count	132 Count
1750008758	198 Count	194 Count	130 Count
1750006955	195 Count	191 Count	128 Count
1750005152	192 Count	188 Count	126 Count
1750003349	189 Count	185 Count	124 Count
1750001582	186 Count	182 Count	122 Count
1749999779	183 Count	179 Count	120 Count
1749997976	180 Count	176 Count	118 Count
1749996173	177 Count	173 Count	116 Count
1749994369	174 Count	170 Count	114 Count
1749992566	171 Count	167 Count	112 Count
1749990763	168 Count	164 Count	110 Count
1749988960	165 Count	161 Count	108 Count
1749987157	162 Count	158 Count	106 Count
1749985354	159 Count	155 Count	104 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)