K0FTT Automobiles

My position About ☰

reset

SR2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1768163611	29 Count	61 Count	29 Count
1768161811	452 Count	1020 Count	430 Count
1768160010	427 Count	955 Count	406 Count
1768158209	405 Count	908 Count	385 Count
1768156409	370 Count	853 Count	359 Count
1768154608	329 Count	761 Count	319 Count
1768152808	292 Count	696 Count	283 Count
1768151006	269 Count	640 Count	261 Count
1768149206	243 Count	580 Count	236 Count
1768147403	198 Count	460 Count	192 Count
1768145602	171 Count	397 Count	166 Count
1768143802	149 Count	322 Count	145 Count
1768142001	108 Count	248 Count	105 Count
1768140200	79 Count	184 Count	77 Count
1768138400	55 Count	129 Count	54 Count
1768136599	31 Count	63 Count	31 Count
1768134799	428 Count	1045 Count	410 Count
1768132998	403 Count	986 Count	386 Count
1768129429	332 Count	802 Count	321 Count
1768127629	308 Count	736 Count	298 Count
1768125829	285 Count	675 Count	276 Count
1768124027	244 Count	549 Count	236 Count
1768122227	220 Count	479 Count	213 Count
1768120426	191 Count	421 Count	186 Count
1768118625	163 Count	361 Count	159 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)