K0FTT Automobiles

My position About ☰

reset

SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1768840227	670 Count	712 Count	421 Count
1768839326	668 Count	711 Count	420 Count
1768838425	665 Count	709 Count	418 Count
1768837524	662 Count	706 Count	416 Count
1768836623	661 Count	703 Count	416 Count
1768835722	658 Count	697 Count	414 Count
1768834842	655 Count	692 Count	412 Count
1768833941	652 Count	690 Count	410 Count
1768833040	650 Count	689 Count	409 Count
1768832139	647 Count	683 Count	407 Count
1768831238	627 Count	656 Count	388 Count
1768830337	618 Count	648 Count	380 Count
1768829436	616 Count	647 Count	379 Count
1768828535	614 Count	646 Count	378 Count
1768827635	611 Count	644 Count	376 Count
1768826734	608 Count	642 Count	374 Count
1768825833	606 Count	641 Count	373 Count
1768824932	603 Count	639 Count	371 Count
1768824031	600 Count	637 Count	369 Count
1768823130	598 Count	636 Count	368 Count
1768822229	595 Count	634 Count	366 Count
1768821329	592 Count	632 Count	364 Count
1768820428	589 Count	630 Count	362 Count
1768819527	588 Count	630 Count	362 Count
1768818626	585 Count	628 Count	360 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)