K0FTT Automobiles

My position About ☰

reset

SP6TK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1750241036	555 Count	390 Count	63 Count
1750239835	538 Count	380 Count	61 Count
1750217048	872 Count	863 Count	157 Count
1750215847	854 Count	845 Count	155 Count
1750214646	832 Count	831 Count	153 Count
1750213445	810 Count	804 Count	149 Count
1750212244	791 Count	780 Count	145 Count
1750211044	770 Count	757 Count	143 Count
1750209843	750 Count	737 Count	138 Count
1750208642	729 Count	714 Count	134 Count
1750207441	707 Count	690 Count	131 Count
1750206240	689 Count	665 Count	127 Count
1750203839	652 Count	614 Count	122 Count
1750202638	636 Count	587 Count	118 Count
1750201437	620 Count	564 Count	116 Count
1750200236	604 Count	543 Count	114 Count
1750197835	564 Count	502 Count	108 Count
1750196634	546 Count	480 Count	106 Count
1750195447	535 Count	459 Count	102 Count
1750194246	524 Count	448 Count	100 Count
1750193045	499 Count	433 Count	98 Count
1750191844	477 Count	415 Count	94 Count
1750190643	458 Count	409 Count	92 Count
1750189442	440 Count	398 Count	90 Count
1750188241	430 Count	388 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)