K0FTT Automobiles

My position About ☰

reset

SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1768853391	16 Count	556 Count
1768851592	15 Count	528 Count
1768849791	14 Count	488 Count
1768847990	13 Count	463 Count
1768846189	12 Count	426 Count
1768844392	11 Count	418 Count
1768842591	10 Count	382 Count
1768840790	9 Count	363 Count
1768838989	8 Count	305 Count
1768837192	7 Count	193 Count
1768835390	6 Count	176 Count
1768833589	5 Count	156 Count
1768831788	4 Count	128 Count
1768829991	3 Count	102 Count
1768828190	2 Count	74 Count
1768826389	1 Count	53 Count
1768824588	0 Count	25 Count
1768822791	31 Count	1005 Count
1768820990	30 Count	985 Count
1768819189	29 Count	956 Count
1768817387	28 Count	932 Count
1768815590	27 Count	917 Count
1768813788	26 Count	911 Count
1768811987	25 Count	904 Count
1768810186	24 Count	869 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)