K0FTT Automobiles

My position About ☰

reset

SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753541003	998 Count	847 Count	225 Count
1753540099	997 Count	847 Count	225 Count
1753539198	996 Count	847 Count	225 Count
1753538289	995 Count	847 Count	225 Count
1753537383	994 Count	847 Count	225 Count
1753536479	989 Count	847 Count	225 Count
1753535577	988 Count	847 Count	225 Count
1753534676	987 Count	847 Count	225 Count
1753533776	986 Count	847 Count	225 Count
1753532875	985 Count	847 Count	225 Count
1753531974	984 Count	847 Count	225 Count
1753531073	982 Count	841 Count	224 Count
1753530172	981 Count	841 Count	224 Count
1753529271	980 Count	840 Count	224 Count
1753528370	979 Count	840 Count	224 Count
1753527469	978 Count	839 Count	224 Count
1753526568	977 Count	839 Count	224 Count
1753525667	976 Count	839 Count	224 Count
1753524766	975 Count	838 Count	224 Count
1753522064	971 Count	831 Count	223 Count
1753521163	970 Count	831 Count	223 Count
1753519363	968 Count	830 Count	223 Count
1753517562	966 Count	830 Count	223 Count
1753516661	965 Count	830 Count	223 Count
1753515760	964 Count	826 Count	223 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)