K0FTT Automobiles

My position About ☰

reset

SQ5STR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1753535423	7 Count	220 Count
1753534522	6 Count	203 Count
1753533621	5 Count	187 Count
1753532720	4 Count	168 Count
1753531819	3 Count	152 Count
1753530919	2 Count	132 Count
1753530018	1 Count	87 Count
1753529117	0 Count	62 Count
1753528216	42 Count	1034 Count
1753527315	41 Count	982 Count
1753526415	40 Count	965 Count
1753525514	39 Count	944 Count
1753524613	38 Count	919 Count
1753523712	37 Count	900 Count
1753522811	36 Count	878 Count
1753521911	35 Count	856 Count
1753519818	34 Count	807 Count
1753518917	33 Count	792 Count
1753518017	32 Count	776 Count
1753517116	31 Count	764 Count
1753516215	30 Count	745 Count
1753515314	29 Count	728 Count
1753514413	28 Count	709 Count
1753513513	27 Count	691 Count
1753512612	26 Count	670 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)