K0FTT Automobiles

My position About ☰

reset

MB7USU-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7USU-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770044945	451 Count	406 Count	139 Count
1770043152	449 Count	404 Count	138 Count
1770041351	448 Count	403 Count	138 Count
1770039550	446 Count	401 Count	137 Count
1770037750	445 Count	400 Count	137 Count
1770035949	443 Count	398 Count	136 Count
1770034148	442 Count	397 Count	136 Count
1770032348	440 Count	395 Count	135 Count
1770030547	439 Count	394 Count	135 Count
1770028746	437 Count	392 Count	134 Count
1770026945	436 Count	391 Count	134 Count
1770025145	434 Count	389 Count	133 Count
1770023344	433 Count	388 Count	133 Count
1770021550	431 Count	386 Count	132 Count
1770019750	430 Count	385 Count	132 Count
1770017949	428 Count	383 Count	131 Count
1770016148	427 Count	382 Count	131 Count
1770014348	425 Count	380 Count	130 Count
1770012547	424 Count	379 Count	130 Count
1770010746	422 Count	377 Count	129 Count
1770008946	421 Count	376 Count	129 Count
1770007145	419 Count	374 Count	128 Count
1770005344	418 Count	373 Count	128 Count
1770003544	416 Count	371 Count	127 Count
1770001743	415 Count	370 Count	127 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)