K0FTT Automobiles

My position About ☰

reset

AF5LI-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object AF5LI-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1757977278	2920	751	24	1359	8062
1757977158	3560	853	25	1336	8061
1757977038	3848	823	25	1338	8061
1757976918	4144	860	28	1346	8061
1757976799	3992	858	25	1341	8061
1757976679	3848	844	32	1340	8060
1757976559	4038	853	25	1342	8062
1757976439	3950	855	41	1349	8060
1757976319	4009	876	45	1351	8060
1757976199	3932	878	19	1351	8059
1757975959	2984	766	30	1340	8061
1757975865	3727	871	86	1376	8061
1757975748	4327	870	87	1386	8060
1757975616	4291	876	81	1388	8060
1757975550	3725	860	105	1385	8060
1757975399	4248	874	95	1390	8060
1757975262	4653	865	88	1392	8060
1757975140	4799	791	76	1379	8061
1757975000	4224	877	73	1370	8060
1757974892	4826	876	74	1389	8060
1757974760	4366	863	56	1368	8060
1757974677	4288	778	95	1390	8060
1757974543	4665	769	84	1399	8061
1757974411	4863	765	80	1396	8060
1757974295	4766	803	83	1398	8061

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)