K0FTT Automobiles

My position About ☰

reset

AF5LI-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object AF5LI-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value3*	Value4*	Value5*
1742489347	3984	58	1449	8163
1742489215	3985	54	1434	8163
1742489092	3985	55	1427	8163
1742488971	3985	55	1416	8163
1742488850	3981	56	1405	8162
1742488727	3980	52	1397	8163
1742488639	3983	62	1402	8162
1742488499	3983	58	1384	8163
1742488384	3983	58	1387	8163
1742488022	3983	60	1385	8163
1742487897	3987	56	1385	8163
1742487774	3982	55	1389	8163
1742487653	3981	58	1396	8164
1742487547	3989	60	1405	8163
1742487410	3978	57	1411	8163
1742487301	3985	60	1413	8163
1742487165	3981	54	1405	8163
1742487048	3983	55	1407	8163
1742486925	3983	57	1400	8163
1742486802	3981	58	1395	8163
1742486696	3987	55	1400	8163
1742486563	3985	53	1395	8163
1742486443	3977	52	1391	8163
1742486200	3984	55	1361	8162
1742486079	3984	57	1357	8162

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)