K0FTT Automobiles

My position About ☰

reset

SP2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762044491	134 Count	133 Count	104 Count
1762042691	130 Count	130 Count	101 Count
1762040890	126 Count	127 Count	98 Count
1762039090	122 Count	124 Count	95 Count
1762037289	118 Count	121 Count	92 Count
1762035488	114 Count	118 Count	89 Count
1762033688	110 Count	115 Count	86 Count
1762031887	106 Count	112 Count	83 Count
1762030087	102 Count	109 Count	80 Count
1762028286	98 Count	106 Count	77 Count
1762026485	94 Count	103 Count	74 Count
1762024685	90 Count	100 Count	71 Count
1762022884	81 Count	92 Count	63 Count
1762021083	77 Count	89 Count	60 Count
1762019283	72 Count	86 Count	57 Count
1762017508	65 Count	83 Count	54 Count
1762015708	61 Count	76 Count	51 Count
1762013907	55 Count	58 Count	46 Count
1762012106	50 Count	51 Count	42 Count
1762010306	46 Count	48 Count	39 Count
1762008505	42 Count	45 Count	36 Count
1762006704	38 Count	42 Count	33 Count
1762004904	34 Count	39 Count	30 Count
1762003103	30 Count	36 Count	27 Count
1762001303	20 Count	27 Count	18 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)