K0FTT Automobiles

My position About ☰

reset

KQ6DI-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1762337910	1205	792	392	784	58
1762337590	1205	792	397	784	58
1762337190	1205	794	402	784	57
1762336470	1205	795	402	788	57
1762335790	1205	797	397	788	58
1762335750	1205	797	402	788	57
1762335030	1205	798	402	792	57
1762334311	1205	800	402	792	58
1762333990	1205	800	402	792	57
1762333590	1205	802	408	792	57
1762332869	1205	803	408	797	57
1762332190	1209	805	408	797	57
1762332150	1205	805	408	797	57
1762331429	1204	806	408	797	57
1762330710	1205	808	408	802	57
1762330390	1205	809	408	802	57
1762329990	1205	809	402	802	57
1762329270	1205	812	413	806	57
1762328590	1205	813	408	806	57
1762328550	1204	813	413	806	57
1762327831	1205	816	408	806	57
1762327109	1205	817	413	810	57
1762326790	1205	818	408	810	58
1762326390	1209	820	408	810	57
1762325669	1205	821	413	810	58

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)