K0FTT Automobiles

My position About ☰

reset

SP2SGL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1768817015	241 Count	396 Count	235 Count
1768815214	224 Count	366 Count	219 Count
1768813413	181 Count	301 Count	177 Count
1768811612	158 Count	257 Count	155 Count
1768809812	105 Count	188 Count	103 Count
1768808011	49 Count	104 Count	48 Count
1768806210	17 Count	44 Count	17 Count
1768804417	511 Count	1004 Count	486 Count
1768802617	487 Count	954 Count	463 Count
1768800816	472 Count	921 Count	449 Count
1768799015	458 Count	893 Count	436 Count
1768797214	440 Count	862 Count	419 Count
1768795414	419 Count	823 Count	399 Count
1768793613	403 Count	790 Count	384 Count
1768791812	387 Count	756 Count	369 Count
1768790011	369 Count	714 Count	352 Count
1768788211	349 Count	677 Count	333 Count
1768786410	331 Count	637 Count	316 Count
1768784609	310 Count	600 Count	296 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)