K0FTT Automobiles

My position About ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770075147	472 Count	778 Count	211 Count
1770073347	471 Count	778 Count	211 Count
1770071546	470 Count	778 Count	211 Count
1770069745	469 Count	778 Count	211 Count
1770067944	468 Count	778 Count	211 Count
1770066144	467 Count	777 Count	211 Count
1770064343	466 Count	777 Count	211 Count
1770062550	465 Count	775 Count	211 Count
1770060750	463 Count	773 Count	210 Count
1770058949	461 Count	770 Count	209 Count
1770057148	460 Count	767 Count	209 Count
1770055348	458 Count	764 Count	208 Count
1770053547	455 Count	756 Count	206 Count
1770051746	454 Count	754 Count	206 Count
1770049945	451 Count	747 Count	204 Count
1770048145	450 Count	742 Count	204 Count
1770046344	448 Count	739 Count	203 Count
1770044543	446 Count	734 Count	202 Count
1770042743	445 Count	733 Count	202 Count
1770040950	444 Count	733 Count	202 Count
1770039149	443 Count	732 Count	202 Count
1770037349	442 Count	731 Count	202 Count
1770035548	441 Count	731 Count	202 Count
1770033747	440 Count	730 Count	202 Count
1770031947	438 Count	729 Count	201 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)