K0FTT Automobiles

My position About ☰

reset

F6ZBY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6ZBY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1770039322	265 Count	739 Count
1770037522	264 Count	735 Count
1770035721	263 Count	733 Count
1770033920	262 Count	731 Count
1770032120	261 Count	728 Count
1770030319	260 Count	726 Count
1770028518	259 Count	723 Count
1770026717	258 Count	721 Count
1770024917	257 Count	719 Count
1770021989	256 Count	717 Count
1770020189	255 Count	715 Count
1770018388	254 Count	713 Count
1770016587	253 Count	711 Count
1770014787	252 Count	709 Count
1770012986	251 Count	707 Count
1770011185	250 Count	705 Count
1770009385	249 Count	704 Count
1770007584	248 Count	700 Count
1770005783	247 Count	699 Count
1770003983	246 Count	697 Count
1770002182	245 Count	695 Count
1770000390	244 Count	693 Count
1769998590	243 Count	691 Count
1769996789	242 Count	689 Count
1769994988	241 Count	687 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)