K0FTT Automobiles

My position About ☰

reset

OK0HCS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0HCS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1761879260	4 Count	119 Count
1761877457	1 Count	56 Count
1761875654	34 Count	1032 Count
1761873851	33 Count	983 Count
1761872048	31 Count	929 Count
1761870245	29 Count	885 Count
1761868441	28 Count	837 Count
1761866638	27 Count	779 Count
1761864871	25 Count	709 Count
1761863068	24 Count	660 Count
1761861264	22 Count	598 Count
1761859461	21 Count	546 Count
1761857658	16 Count	488 Count
1761855855	15 Count	451 Count
1761854052	13 Count	408 Count
1761852249	12 Count	366 Count
1761850446	10 Count	320 Count
1761848643	7 Count	265 Count
1761846840	5 Count	215 Count
1761845037	4 Count	170 Count
1761843271	2 Count	120 Count
1761841468	1 Count	69 Count
1761839665	35 Count	1027 Count
1761837862	34 Count	919 Count
1761836058	32 Count	867 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)