K0FTT Automobiles

My position About ☰

reset

SR2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770113733	58 Count	155 Count	57 Count
1770111932	27 Count	76 Count	27 Count
1770110131	440 Count	1015 Count	420 Count
1770108331	409 Count	937 Count	390 Count
1770106530	381 Count	869 Count	363 Count
1770104729	344 Count	778 Count	327 Count
1770102929	306 Count	682 Count	290 Count
1770102293	301 Count	680 Count	290 Count
1770101176	296 Count	678 Count	290 Count
1770099374	257 Count	590 Count	252 Count
1770097574	193 Count	449 Count	189 Count
1770095773	149 Count	360 Count	146 Count
1770093971	111 Count	275 Count	109 Count
1770092171	74 Count	180 Count	73 Count
1770090370	36 Count	90 Count	36 Count
1770088569	416 Count	1077 Count	404 Count
1770086769	381 Count	990 Count	370 Count
1770084968	345 Count	899 Count	335 Count
1770083168	305 Count	798 Count	296 Count
1770081367	270 Count	706 Count	262 Count
1770079566	238 Count	623 Count	231 Count
1770077766	209 Count	544 Count	203 Count
1770075965	174 Count	458 Count	169 Count
1770074164	139 Count	365 Count	135 Count
1770072364	110 Count	290 Count	107 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)