K0FTT Automobiles

My position About ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1766002097	894 Count	301 Count
1766001497	888 Count	300 Count
1766000897	882 Count	298 Count
1766000297	879 Count	298 Count
1765999697	871 Count	297 Count
1765999097	863 Count	294 Count
1765998497	862 Count	294 Count
1765997897	854 Count	292 Count
1765997297	849 Count	291 Count
1765996697	846 Count	290 Count
1765996097	841 Count	289 Count
1765995497	834 Count	287 Count
1765994897	832 Count	286 Count
1765994296	825 Count	285 Count
1765993696	818 Count	283 Count
1765993096	817 Count	283 Count
1765992496	807 Count	282 Count
1765991896	799 Count	279 Count
1765991296	794 Count	277 Count
1765990696	785 Count	274 Count
1765990096	775 Count	270 Count
1765989496	771 Count	268 Count
1765988896	764 Count	265 Count
1765988296	755 Count	262 Count
1765987695	751 Count	260 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)