K0FTT Automobiles

My position About ☰

reset

SP6RGZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RGZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1761873899	355 Count	190 Count	190 Count
1761872098	353 Count	189 Count	189 Count
1761870297	349 Count	186 Count	186 Count
1761868496	346 Count	184 Count	184 Count
1761866695	344 Count	183 Count	183 Count
1761864895	342 Count	182 Count	182 Count
1761863094	339 Count	180 Count	180 Count
1761861293	337 Count	179 Count	179 Count
1761859501	335 Count	178 Count	178 Count
1761857700	333 Count	177 Count	177 Count
1761855899	331 Count	176 Count	176 Count
1761854099	329 Count	175 Count	175 Count
1761852298	327 Count	174 Count	174 Count
1761850497	325 Count	173 Count	173 Count
1761848696	323 Count	172 Count	172 Count
1761846896	321 Count	171 Count	171 Count
1761845095	319 Count	170 Count	170 Count
1761843294	317 Count	169 Count	169 Count
1761841493	315 Count	168 Count	168 Count
1761839693	313 Count	167 Count	167 Count
1761837900	311 Count	166 Count	166 Count
1761836099	309 Count	165 Count	165 Count
1761834299	307 Count	164 Count	164 Count
1761832498	305 Count	163 Count	163 Count
1761830697	303 Count	162 Count	162 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)