K0FTT Automobiles

My position About ☰

reset

SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1768836511	46 Count	627 Count
1768834711	45 Count	617 Count
1768832910	44 Count	606 Count
1768831110	43 Count	595 Count
1768829309	42 Count	584 Count
1768827508	41 Count	574 Count
1768825715	40 Count	563 Count
1768823914	39 Count	552 Count
1768822113	38 Count	542 Count
1768820313	37 Count	531 Count
1768818512	36 Count	520 Count
1768816712	35 Count	509 Count
1768814911	34 Count	498 Count
1768813110	33 Count	487 Count
1768811309	32 Count	476 Count
1768809509	31 Count	465 Count
1768807708	30 Count	454 Count
1768805907	29 Count	437 Count
1768804115	28 Count	426 Count
1768802314	27 Count	415 Count
1768800513	26 Count	404 Count
1768798713	25 Count	393 Count
1768796912	24 Count	381 Count
1768795111	23 Count	370 Count
1768793311	22 Count	359 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)