K0FTT Automobiles

My position About ☰

reset

OK2ILA-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2ILA-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1757454206	32 Count	576 Count
1757453003	31 Count	543 Count
1757451801	30 Count	515 Count
1757450604	29 Count	486 Count
1757449394	28 Count	455 Count
1757447417	22 Count	358 Count
1757446429	16 Count	329 Count
1757445226	14 Count	286 Count
1757444024	13 Count	250 Count
1757442820	12 Count	232 Count
1757441617	11 Count	210 Count
1757440414	10 Count	190 Count
1757439210	9 Count	177 Count
1757438007	8 Count	165 Count
1757436804	7 Count	147 Count
1757435601	6 Count	131 Count
1757434398	5 Count	117 Count
1757433195	4 Count	99 Count
1757431992	3 Count	81 Count
1757430789	2 Count	61 Count
1757429587	1 Count	43 Count
1757427181	33 Count	1031 Count
1757425984	32 Count	996 Count
1757424774	31 Count	968 Count
1757423571	30 Count	934 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)