K0FTT Automobiles

My position About ☰

reset

OK1FWG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1FWG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1763881565	317 Count	731 Count	303 Count
1763879762	314 Count	688 Count	302 Count
1763877958	307 Count	621 Count	296 Count
1763876155	283 Count	565 Count	273 Count
1763874352	253 Count	499 Count	244 Count
1763872549	218 Count	436 Count	211 Count
1763870745	185 Count	367 Count	179 Count
1763868942	156 Count	312 Count	151 Count
1763867138	127 Count	254 Count	123 Count
1763865330	95 Count	191 Count	93 Count
1763863527	66 Count	130 Count	65 Count
1763861724	27 Count	59 Count	27 Count
1763859921	332 Count	1059 Count	309 Count
1763858118	328 Count	1000 Count	307 Count
1763856314	327 Count	948 Count	307 Count
1763854510	324 Count	902 Count	305 Count
1763852707	306 Count	838 Count	288 Count
1763850900	270 Count	767 Count	254 Count
1763849095	241 Count	704 Count	226 Count
1763847292	218 Count	646 Count	204 Count
1763845489	188 Count	581 Count	175 Count
1763843686	162 Count	520 Count	151 Count
1763841883	146 Count	468 Count	136 Count
1763840080	124 Count	413 Count	115 Count
1763838277	97 Count	350 Count	89 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)