K0FTT Automobiles

My position About ☰

reset

WD4ITE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WD4ITE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753221650	905 Count	308 Count	308 Count
1753221050	904 Count	308 Count	308 Count
1753220449	902 Count	307 Count	307 Count
1753219848	900 Count	306 Count	306 Count
1753219247	899 Count	306 Count	306 Count
1753218647	897 Count	305 Count	305 Count
1753218046	895 Count	304 Count	304 Count
1753217445	894 Count	304 Count	304 Count
1753216844	892 Count	303 Count	303 Count
1753216244	890 Count	302 Count	302 Count
1753215643	889 Count	302 Count	302 Count
1753215042	887 Count	301 Count	301 Count
1753214442	884 Count	299 Count	299 Count
1753213841	883 Count	299 Count	299 Count
1753213267	881 Count	298 Count	298 Count
1753212666	879 Count	297 Count	297 Count
1753212066	878 Count	297 Count	297 Count
1753211465	876 Count	296 Count	296 Count
1753210864	874 Count	295 Count	295 Count
1753210263	873 Count	295 Count	295 Count
1753209662	869 Count	292 Count	292 Count
1753209062	868 Count	292 Count	292 Count
1753208461	866 Count	291 Count	291 Count
1753207860	864 Count	290 Count	290 Count
1753207259	863 Count	290 Count	290 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)