K0FTT Automobiles

My position About ☰

reset

SQ8RZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8RZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1763704691	257 Count	540 Count	200 Count
1763703783	253 Count	534 Count	197 Count
1763702878	250 Count	526 Count	195 Count
1763701974	247 Count	520 Count	193 Count
1763701066	242 Count	509 Count	189 Count
1763700160	238 Count	501 Count	186 Count
1763699252	232 Count	490 Count	181 Count
1763698345	228 Count	481 Count	178 Count
1763697438	224 Count	469 Count	175 Count
1763696534	219 Count	455 Count	171 Count
1763695736	210 Count	446 Count	167 Count
1763694832	207 Count	438 Count	165 Count
1763693929	203 Count	429 Count	162 Count
1763693028	201 Count	420 Count	161 Count
1763692126	197 Count	410 Count	158 Count
1763691223	194 Count	403 Count	156 Count
1763690316	189 Count	391 Count	152 Count
1763689413	187 Count	383 Count	151 Count
1763688507	183 Count	373 Count	148 Count
1763687605	180 Count	364 Count	146 Count
1763686696	174 Count	352 Count	141 Count
1763685794	168 Count	344 Count	136 Count
1763684889	153 Count	317 Count	122 Count
1763683987	150 Count	311 Count	120 Count
1763683078	145 Count	301 Count	116 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)