K0FTT Automobiles

My position About ☰

reset

SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1768830658	44 Count	278 Count	29 Count
1768828977	41 Count	274 Count	27 Count
1768827296	37 Count	263 Count	24 Count
1768825616	34 Count	258 Count	22 Count
1768824184	27 Count	254 Count	20 Count
1768822503	24 Count	244 Count	18 Count
1768820822	21 Count	221 Count	16 Count
1768819141	18 Count	202 Count	14 Count
1768817461	13 Count	146 Count	10 Count
1768815780	11 Count	126 Count	9 Count
1768814099	5 Count	85 Count	4 Count
1768812418	2 Count	49 Count	2 Count
1768810738	105 Count	1029 Count	63 Count
1768809057	102 Count	971 Count	61 Count
1768807376	95 Count	895 Count	55 Count
1768805695	93 Count	844 Count	54 Count
1768804015	91 Count	802 Count	53 Count
1768802583	83 Count	773 Count	50 Count
1768800902	80 Count	746 Count	48 Count
1768799221	77 Count	718 Count	46 Count
1768797540	74 Count	688 Count	44 Count
1768795860	70 Count	653 Count	41 Count
1768794179	68 Count	618 Count	40 Count
1768792498	65 Count	585 Count	38 Count
1768790817	62 Count	553 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)