K0FTT Automobiles

My position About ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1768818357	77 Count	374 Count	64 Count
1768816556	61 Count	331 Count	50 Count
1768814755	49 Count	278 Count	39 Count
1768812962	36 Count	230 Count	32 Count
1768811162	28 Count	190 Count	25 Count
1768809360	20 Count	143 Count	19 Count
1768807559	9 Count	79 Count	9 Count
1768805759	251 Count	1042 Count	222 Count
1768803958	240 Count	983 Count	213 Count
1768802157	231 Count	931 Count	205 Count
1768800356	219 Count	873 Count	195 Count
1768798556	205 Count	788 Count	182 Count
1768796755	188 Count	725 Count	167 Count
1768794954	176 Count	657 Count	156 Count
1768793153	164 Count	597 Count	145 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)