K0FTT Automobiles

My position About ☰

reset

SP9DAT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9DAT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1749274358	72 Count	255 Count	54 Count
1749273457	69 Count	247 Count	52 Count
1749272556	65 Count	241 Count	49 Count
1749271655	61 Count	232 Count	46 Count
1749270754	57 Count	226 Count	43 Count
1749269853	53 Count	217 Count	40 Count
1749268952	49 Count	210 Count	37 Count
1749268051	45 Count	177 Count	34 Count
1749267150	41 Count	152 Count	31 Count
1749266249	37 Count	140 Count	28 Count
1749265348	33 Count	134 Count	25 Count
1749264448	29 Count	125 Count	22 Count
1749263547	25 Count	107 Count	19 Count
1749262646	21 Count	68 Count	16 Count
1749261745	17 Count	56 Count	13 Count
1749260844	14 Count	33 Count	11 Count
1749259943	10 Count	26 Count	8 Count
1749259042	7 Count	17 Count	6 Count
1749258141	3 Count	10 Count	3 Count
1749257240	802 Count	1002 Count	487 Count
1749256340	798 Count	994 Count	484 Count
1749255439	794 Count	986 Count	481 Count
1749254538	790 Count	979 Count	478 Count
1749253637	786 Count	971 Count	475 Count
1749252736	782 Count	964 Count	472 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)