K0FTT Automobiles

My position About ☰

reset

SP9LJE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1761857732	106 Count	109 Count	93 Count
1761855930	105 Count	108 Count	93 Count
1761854121	104 Count	108 Count	93 Count
1761852320	103 Count	108 Count	93 Count
1761850519	102 Count	108 Count	93 Count
1761848719	97 Count	104 Count	89 Count
1761846927	96 Count	104 Count	89 Count
1761845127	95 Count	104 Count	89 Count
1761843325	94 Count	104 Count	89 Count
1761841524	76 Count	79 Count	72 Count
1761839724	47 Count	51 Count	44 Count
1761837923	33 Count	37 Count	31 Count
1761836122	22 Count	26 Count	21 Count
1761834322	11 Count	15 Count	11 Count
1761832521	510 Count	1028 Count	470 Count
1761830721	497 Count	999 Count	458 Count
1761828920	482 Count	978 Count	444 Count
1761827119	471 Count	968 Count	434 Count
1761825325	460 Count	958 Count	424 Count
1761823525	446 Count	944 Count	411 Count
1761821724	435 Count	934 Count	401 Count
1761819923	415 Count	912 Count	382 Count
1761818123	413 Count	901 Count	381 Count
1761816322	387 Count	875 Count	356 Count
1761814521	376 Count	865 Count	346 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)