K0FTT Automobiles

My position About ☰

reset

IZ2WZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ2WZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1758158511	6 Count	121 Count
1758157607	5 Count	110 Count
1758156702	4 Count	96 Count
1758155798	3 Count	70 Count
1758154893	2 Count	57 Count
1758153989	1 Count	29 Count
1758153084	0 Count	10 Count
1758152180	55 Count	1004 Count
1758151275	54 Count	993 Count
1758150371	53 Count	973 Count
1758149466	52 Count	950 Count
1758148561	51 Count	938 Count
1758147657	50 Count	917 Count
1758146752	49 Count	894 Count
1758145848	48 Count	877 Count
1758144943	47 Count	860 Count
1758144039	46 Count	843 Count
1758143134	45 Count	833 Count
1758142230	44 Count	804 Count
1758141325	43 Count	790 Count
1758140421	42 Count	765 Count
1758139516	41 Count	754 Count
1758138611	40 Count	733 Count
1758137707	39 Count	722 Count
1758136802	38 Count	705 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)