K0FTT Automobiles

My position About ☰

reset

SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1770080878	857 Count	133 Count	34 Count
1770079977	856 Count	133 Count	34 Count
1770079076	855 Count	132 Count	34 Count
1770078175	854 Count	131 Count	34 Count
1770077274	853 Count	131 Count	34 Count
1770076373	852 Count	130 Count	34 Count
1770075472	851 Count	130 Count	34 Count
1770074571	850 Count	130 Count	34 Count
1770073694	849 Count	130 Count	34 Count
1770072793	848 Count	130 Count	34 Count
1770071892	847 Count	130 Count	34 Count
1770070991	846 Count	130 Count	34 Count
1770070090	845 Count	130 Count	34 Count
1770069189	844 Count	130 Count	34 Count
1770068287	843 Count	130 Count	34 Count
1770067385	842 Count	130 Count	34 Count
1770066484	841 Count	130 Count	34 Count
1770065583	840 Count	130 Count	34 Count
1770064683	839 Count	130 Count	34 Count
1770063782	838 Count	130 Count	34 Count
1770062881	837 Count	130 Count	34 Count
1770061979	836 Count	130 Count	34 Count
1770061079	835 Count	130 Count	34 Count
1770060177	834 Count	130 Count	34 Count
1770059276	833 Count	130 Count	34 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)