K0FTT Automobiles

My position About ☰

reset

SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1766072114	6 Count	653 Count
1766071879	5 Count	634 Count
1766070139	4 Count	549 Count
1766068397	3 Count	474 Count
1766066655	2 Count	354 Count
1766064914	1 Count	281 Count
1766064681	0 Count	230 Count
1766062940	16 Count	1039 Count
1766061198	15 Count	975 Count
1766059457	14 Count	920 Count
1766057716	13 Count	857 Count
1766057477	12 Count	848 Count
1766055735	11 Count	793 Count
1766053994	10 Count	690 Count
1766052253	9 Count	612 Count
1766050511	8 Count	537 Count
1766050276	7 Count	531 Count
1766048535	6 Count	480 Count
1766046793	5 Count	449 Count
1766045052	4 Count	413 Count
1766043311	3 Count	359 Count
1766043074	2 Count	345 Count
1766041333	1 Count	259 Count
1766039592	0 Count	64 Count
1766037850	21 Count	1029 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)