K0FTT Automobiles

My position About ☰

reset

SP3KAU-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KAU-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1768830497	108 Count	140 Count	23 Count
1768828697	102 Count	131 Count	21 Count
1768826896	96 Count	125 Count	19 Count
1768825095	92 Count	121 Count	19 Count
1768823084	88 Count	118 Count	19 Count
1768821283	83 Count	108 Count	18 Count
1768819482	79 Count	102 Count	18 Count
1768817681	75 Count	94 Count	18 Count
1768815881	70 Count	89 Count	17 Count
1768814080	64 Count	80 Count	15 Count
1768812279	58 Count	68 Count	13 Count
1768810478	52 Count	59 Count	12 Count
1768808677	47 Count	54 Count	11 Count
1768806876	41 Count	47 Count	9 Count
1768805075	34 Count	40 Count	6 Count
1768803275	28 Count	31 Count	4 Count
1768801858	23 Count	21 Count	2 Count
1768800057	16 Count	8 Count	1 Count
1768798256	12 Count	4 Count	1 Count
1768796456	8 Count	3 Count	1 Count
1768794655	4 Count	2 Count	1 Count
1768792854	1001 Count	311 Count	46 Count
1768791053	996 Count	308 Count	45 Count
1768789252	992 Count	306 Count	45 Count
1768787451	988 Count	304 Count	45 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)