K0FTT Automobiles

My position About ☰

reset

SQ9PD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766007520	14 Count	170 Count	10 Count
1766006620	11 Count	111 Count	8 Count
1766005719	6 Count	74 Count	4 Count
1766004818	5 Count	55 Count	4 Count
1766003917	2 Count	34 Count	2 Count
1766003016	78 Count	1015 Count	49 Count
1766002166	71 Count	940 Count	44 Count
1766002116	75 Count	994 Count	47 Count
1766001215	71 Count	940 Count	44 Count
1766000314	70 Count	929 Count	44 Count
1765999413	66 Count	863 Count	41 Count
1765998513	62 Count	818 Count	38 Count
1765997612	60 Count	796 Count	37 Count
1765996712	58 Count	781 Count	36 Count
1765995811	54 Count	723 Count	33 Count
1765994910	51 Count	654 Count	31 Count
1765994009	47 Count	548 Count	28 Count
1765993109	46 Count	544 Count	28 Count
1765992208	45 Count	538 Count	28 Count
1765991308	40 Count	476 Count	24 Count
1765990407	38 Count	453 Count	23 Count
1765989506	35 Count	405 Count	21 Count
1765988606	34 Count	399 Count	21 Count
1765987729	29 Count	392 Count	21 Count
1765986827	25 Count	344 Count	18 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)