K0FTT Automobiles

My position About ☰

reset

SR2ST-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1765993962	524 Count	320 Count	80 Count
1765992281	506 Count	312 Count	78 Count
1765990600	487 Count	304 Count	76 Count
1765988919	476 Count	297 Count	74 Count
1765987238	462 Count	289 Count	72 Count
1765985558	451 Count	282 Count	70 Count
1765983877	438 Count	274 Count	68 Count
1765982196	427 Count	267 Count	67 Count
1765980515	416 Count	260 Count	65 Count
1765977403	390 Count	244 Count	61 Count
1765975722	378 Count	237 Count	59 Count
1765974042	366 Count	229 Count	57 Count
1765972361	357 Count	223 Count	56 Count
1765970680	346 Count	215 Count	54 Count
1765968999	334 Count	207 Count	52 Count
1765967318	324 Count	200 Count	50 Count
1765965638	294 Count	192 Count	48 Count
1765963957	281 Count	185 Count	46 Count
1765962276	270 Count	177 Count	44 Count
1765960595	260 Count	170 Count	43 Count
1765958914	250 Count	163 Count	41 Count
1765957483	238 Count	156 Count	39 Count
1765955802	226 Count	148 Count	37 Count
1765954122	215 Count	141 Count	35 Count
1765952441	204 Count	133 Count	33 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)