K0FTT Automobiles

My position About ☰

reset

SQ5STR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1750041657	18 Count	547 Count
1750040756	17 Count	522 Count
1750039855	16 Count	487 Count
1750038955	15 Count	461 Count
1750038054	14 Count	434 Count
1750037153	13 Count	404 Count
1750036252	12 Count	362 Count
1750035351	11 Count	328 Count
1750034450	10 Count	289 Count
1750033549	9 Count	265 Count
1750032649	8 Count	242 Count
1750031748	7 Count	216 Count
1750030847	6 Count	183 Count
1750029946	5 Count	158 Count
1750029045	4 Count	129 Count
1750028144	3 Count	99 Count
1750027244	2 Count	74 Count
1750026343	1 Count	46 Count
1750025442	0 Count	18 Count
1750024541	61 Count	1016 Count
1750023640	60 Count	995 Count
1750022739	59 Count	979 Count
1750021839	58 Count	955 Count
1750020959	57 Count	938 Count
1750020058	56 Count	923 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)