K0FTT Automobiles

My position About ☰

reset

SQ9APP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9APP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1768830529	106 Count	514 Count	91 Count
1768828728	89 Count	409 Count	77 Count
1768826927	60 Count	288 Count	51 Count
1768825126	39 Count	189 Count	33 Count
1768823326	20 Count	100 Count	16 Count
1768823169	18 Count	87 Count	15 Count
1768821468	215 Count	1083 Count	191 Count
1768819668	189 Count	957 Count	167 Count
1768818804	178 Count	915 Count	157 Count
1768817003	162 Count	810 Count	144 Count
1768815202	141 Count	700 Count	125 Count
1768813402	121 Count	592 Count	107 Count
1768813305	118 Count	584 Count	105 Count
1768812628	108 Count	539 Count	98 Count
1768810827	88 Count	410 Count	81 Count
1768809026	58 Count	270 Count	54 Count
1768807225	27 Count	118 Count	26 Count
1768805424	178 Count	1051 Count	156 Count
1768803623	156 Count	950 Count	137 Count
1768801823	134 Count	827 Count	117 Count
1768800022	114 Count	694 Count	101 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)