K0FTT Automobiles

My position About ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1770107062	1 Count	0 Count	0 Count
1770106997	0 Count	0 Count	0 Count
1770106905	1000 Count	169 Count	82 Count
1770106785	998 Count	169 Count	82 Count
1770106757	997 Count	169 Count	82 Count
1770106741	996 Count	169 Count	82 Count
1770106683	996 Count	169 Count	82 Count
1770106667	996 Count	169 Count	82 Count
1770106645	995 Count	169 Count	82 Count
1770106581	994 Count	169 Count	82 Count
1770106541	993 Count	169 Count	82 Count
1770106493	992 Count	169 Count	82 Count
1770106370	991 Count	169 Count	82 Count
1770106308	990 Count	169 Count	82 Count
1770106248	989 Count	169 Count	82 Count
1770106145	987 Count	169 Count	82 Count
1770106125	987 Count	169 Count	82 Count
1770106113	986 Count	169 Count	82 Count
1770106059	985 Count	169 Count	82 Count
1770105990	984 Count	169 Count	82 Count
1770105966	983 Count	169 Count	82 Count
1770105949	983 Count	169 Count	82 Count
1770105903	982 Count	169 Count	82 Count
1770105796	981 Count	169 Count	82 Count
1770105732	980 Count	169 Count	82 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)