K0FTT Automobiles

My position About ☰

reset

SQ2MO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*
1768844039	33 Count	343 Count	15 Count
1768843438	32 Count	329 Count	15 Count
1768842837	31 Count	318 Count	15 Count
1768842236	30 Count	311 Count	15 Count
1768841636	29 Count	297 Count	15 Count
1768841035	28 Count	283 Count	15 Count
1768840434	27 Count	275 Count	15 Count
1768839833	26 Count	262 Count	15 Count
1768839233	25 Count	246 Count	15 Count
1768838632	24 Count	235 Count	15 Count
1768838031	23 Count	220 Count	15 Count
1768837430	22 Count	207 Count	15 Count
1768836830	18 Count	172 Count	12 Count
1768836229	15 Count	147 Count	10 Count
1768835628	13 Count	119 Count	9 Count
1768835027	9 Count	97 Count	6 Count
1768834426	2 Count	55 Count	0 Count
1768833826	1 Count	38 Count	0 Count
1768833225	0 Count	25 Count	0 Count
1768832624	116 Count	1004 Count	55 Count
1768832023	115 Count	990 Count	55 Count
1768831423	114 Count	975 Count	55 Count
1768830822	113 Count	961 Count	55 Count
1768830221	108 Count	933 Count	51 Count
1768829620	101 Count	907 Count	45 Count

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 0.01, 0

Value5: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)