K0FTT Automobiles

My position About ☰

reset

SR2CA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1761984565	137 Count	633 Count	87 Count
1761982884	134 Count	618 Count	85 Count
1761981204	130 Count	606 Count	83 Count
1761979772	124 Count	591 Count	81 Count
1761978092	122 Count	580 Count	80 Count
1761976413	119 Count	563 Count	78 Count
1761974730	116 Count	551 Count	76 Count
1761973049	113 Count	536 Count	74 Count
1761971369	110 Count	523 Count	72 Count
1761969688	107 Count	509 Count	70 Count
1761968007	104 Count	494 Count	68 Count
1761966326	102 Count	483 Count	67 Count
1761964645	99 Count	471 Count	65 Count
1761962964	96 Count	457 Count	63 Count
1761961284	93 Count	446 Count	61 Count
1761959603	89 Count	433 Count	59 Count
1761958173	84 Count	420 Count	58 Count
1761956492	81 Count	406 Count	56 Count
1761954811	78 Count	388 Count	54 Count
1761953130	75 Count	367 Count	52 Count
1761951450	72 Count	348 Count	50 Count
1761949770	69 Count	330 Count	48 Count
1761948088	66 Count	312 Count	46 Count
1761946407	63 Count	291 Count	44 Count
1761944726	61 Count	274 Count	43 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)