K0FTT Automobiles

My position About ☰

reset

IU3ISP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU3ISP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762237583	79 Count	657 Count	61 Count
1762235779	73 Count	593 Count	56 Count
1762233976	69 Count	538 Count	53 Count
1762232172	63 Count	490 Count	48 Count
1762230368	62 Count	486 Count	48 Count
1762228564	58 Count	441 Count	45 Count
1762226760	52 Count	394 Count	40 Count
1762224957	47 Count	333 Count	36 Count
1762223152	42 Count	287 Count	32 Count
1762221349	36 Count	247 Count	27 Count
1762214177	10 Count	76 Count	9 Count
1762210569	144 Count	1012 Count	100 Count
1762208765	141 Count	973 Count	98 Count
1762206961	137 Count	936 Count	95 Count
1762205157	133 Count	916 Count	92 Count
1762201550	126 Count	862 Count	87 Count
1762199746	125 Count	852 Count	87 Count
1762197989	118 Count	818 Count	85 Count
1762196185	115 Count	779 Count	83 Count
1762194381	109 Count	740 Count	78 Count
1762188970	101 Count	697 Count	73 Count
1762187166	95 Count	672 Count	68 Count
1762185362	93 Count	654 Count	67 Count
1762172779	60 Count	410 Count	45 Count
1762170975	56 Count	375 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)