K0FTT Automobiles

My position About ☰

reset

F5BYL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5BYL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1768850392	310 Count	560 Count	278 Count
1768849789	302 Count	541 Count	271 Count
1768849186	295 Count	525 Count	265 Count
1768848582	286 Count	512 Count	257 Count
1768847975	274 Count	490 Count	246 Count
1768847372	262 Count	470 Count	235 Count
1768846162	236 Count	427 Count	211 Count
1768845559	228 Count	412 Count	204 Count
1768844956	220 Count	396 Count	197 Count
1768844352	210 Count	377 Count	188 Count
1768843871	200 Count	366 Count	183 Count
1768843267	190 Count	352 Count	174 Count
1768842664	179 Count	334 Count	164 Count
1768842060	170 Count	320 Count	156 Count
1768841457	151 Count	289 Count	138 Count
1768840854	127 Count	255 Count	115 Count
1768840251	119 Count	238 Count	108 Count
1768839647	107 Count	213 Count	97 Count
1768839044	96 Count	190 Count	87 Count
1768838440	91 Count	180 Count	83 Count
1768837837	74 Count	149 Count	67 Count
1768837233	58 Count	120 Count	52 Count
1768836630	47 Count	96 Count	42 Count
1768836027	44 Count	90 Count	40 Count
1768835423	35 Count	73 Count	32 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)