K0FTT Automobiles

My position About ☰

reset

SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1768848558	11 Count	719 Count
1768846756	10 Count	669 Count
1768844959	9 Count	625 Count
1768843158	8 Count	567 Count
1768841357	7 Count	525 Count
1768839556	6 Count	434 Count
1768837759	5 Count	280 Count
1768835958	4 Count	246 Count
1768834156	3 Count	207 Count
1768832355	2 Count	167 Count
1768830559	1 Count	118 Count
1768828758	0 Count	66 Count
1768826957	22 Count	1044 Count
1768825155	21 Count	981 Count
1768823358	20 Count	940 Count
1768821557	19 Count	915 Count
1768819755	18 Count	872 Count
1768817954	17 Count	833 Count
1768816158	16 Count	779 Count
1768814357	15 Count	733 Count
1768812555	14 Count	685 Count
1768810754	13 Count	603 Count
1768808957	12 Count	482 Count
1768807156	11 Count	446 Count
1768805355	10 Count	406 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)