K0FTT Automobiles

My position About ☰

reset

MB7USU-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7USU-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1768183709	210 Count	109 Count	38 Count
1768181908	209 Count	108 Count	38 Count
1768180107	207 Count	106 Count	37 Count
1768178307	206 Count	105 Count	37 Count
1768176506	204 Count	103 Count	36 Count
1768174705	203 Count	102 Count	36 Count
1768172904	201 Count	100 Count	35 Count
1768171104	200 Count	99 Count	35 Count
1768169303	198 Count	97 Count	34 Count
1768167502	197 Count	96 Count	34 Count
1768165702	195 Count	94 Count	33 Count
1768163905	194 Count	93 Count	33 Count
1768162104	192 Count	91 Count	32 Count
1768160304	191 Count	90 Count	32 Count
1768158503	189 Count	88 Count	31 Count
1768156702	188 Count	87 Count	31 Count
1768154902	186 Count	85 Count	30 Count
1768153101	185 Count	84 Count	30 Count
1768151300	183 Count	82 Count	29 Count
1768149500	182 Count	81 Count	29 Count
1768147699	180 Count	79 Count	28 Count
1768145898	179 Count	78 Count	28 Count
1768144098	177 Count	76 Count	27 Count
1768142305	176 Count	75 Count	27 Count
1768140504	174 Count	73 Count	26 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)