K0FTT Automobiles

My position About ☰

reset

SQ2MO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1758175069	77 Count	228 Count
1758174468	75 Count	212 Count
1758173867	72 Count	191 Count
1758173266	70 Count	173 Count
1758172665	67 Count	163 Count
1758172064	65 Count	155 Count
1758171463	63 Count	149 Count
1758170261	59 Count	140 Count
1758169661	57 Count	133 Count
1758169060	55 Count	130 Count
1758168459	53 Count	128 Count
1758167858	51 Count	121 Count
1758166657	46 Count	115 Count
1758166056	44 Count	109 Count
1758165483	38 Count	103 Count
1758164882	36 Count	97 Count
1758164281	34 Count	91 Count
1758163680	32 Count	85 Count
1758163080	30 Count	79 Count
1758162479	28 Count	72 Count
1758161878	26 Count	67 Count
1758161277	24 Count	61 Count
1758160677	22 Count	55 Count
1758160076	20 Count	51 Count
1758159475	17 Count	47 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)