K0FTT Automobiles

My position About ☰

reset

SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1762027538	188 Count	329 Count	121 Count
1762025857	185 Count	324 Count	119 Count
1762024176	178 Count	312 Count	113 Count
1762022495	175 Count	306 Count	111 Count
1762020815	173 Count	302 Count	110 Count
1762019134	171 Count	297 Count	109 Count
1762017453	168 Count	286 Count	107 Count
1762015772	165 Count	281 Count	105 Count
1762014092	162 Count	277 Count	103 Count
1762012411	159 Count	272 Count	101 Count
1762010730	156 Count	267 Count	99 Count
1762009049	153 Count	263 Count	97 Count
1762007369	151 Count	259 Count	96 Count
1762005937	145 Count	255 Count	95 Count
1762004256	142 Count	250 Count	93 Count
1762002575	140 Count	242 Count	92 Count
1762000894	137 Count	237 Count	90 Count
1761999214	135 Count	234 Count	89 Count
1761997533	132 Count	225 Count	87 Count
1761995852	129 Count	220 Count	85 Count
1761994171	116 Count	204 Count	73 Count
1761992490	113 Count	200 Count	71 Count
1761990810	110 Count	196 Count	69 Count
1761989129	107 Count	191 Count	67 Count
1761987448	102 Count	184 Count	63 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)