K0FTT Automobiles

My position About ☰

reset

EA4ATS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765964460	1 Count	97 Count
1765962656	0 Count	43 Count
1765960853	16 Count	1051 Count
1765959049	15 Count	998 Count
1765957246	14 Count	946 Count
1765955442	13 Count	900 Count
1765953675	12 Count	826 Count
1765951872	11 Count	731 Count
1765950067	10 Count	595 Count
1765948264	9 Count	500 Count
1765946461	8 Count	438 Count
1765944657	7 Count	391 Count
1765942853	6 Count	338 Count
1765941050	5 Count	292 Count
1765939246	4 Count	240 Count
1765937443	3 Count	190 Count
1765935674	2 Count	143 Count
1765933870	1 Count	94 Count
1765932067	0 Count	44 Count
1765930263	12 Count	1045 Count
1765928460	11 Count	995 Count
1765926656	10 Count	949 Count
1765924853	9 Count	896 Count
1765923049	8 Count	833 Count
1765921246	7 Count	747 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)