K0FTT Automobiles

My position About ☰

reset

SQ9MJ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9MJ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1770082994	43 Count	382 Count	32 Count
1770082093	40 Count	344 Count	30 Count
1770081192	35 Count	308 Count	26 Count
1770080291	30 Count	276 Count	22 Count
1770079390	26 Count	236 Count	19 Count
1770078489	23 Count	206 Count	17 Count
1770077588	18 Count	172 Count	13 Count
1770076687	14 Count	141 Count	10 Count
1770075787	10 Count	108 Count	7 Count
1770074885	6 Count	68 Count	5 Count
1770073984	3 Count	34 Count	3 Count
1770073083	108 Count	1001 Count	81 Count
1770072182	104 Count	961 Count	78 Count
1770071281	101 Count	919 Count	77 Count
1770070380	97 Count	883 Count	74 Count
1770069486	95 Count	838 Count	73 Count
1770068578	92 Count	798 Count	71 Count
1770067677	90 Count	763 Count	70 Count
1770066777	84 Count	719 Count	66 Count
1770065875	82 Count	681 Count	65 Count
1770064984	77 Count	635 Count	61 Count
1770064074	75 Count	603 Count	60 Count
1770063172	71 Count	571 Count	57 Count
1770061390	59 Count	499 Count	52 Count
1770059588	37 Count	362 Count	32 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)