K0FTT Automobiles

My position About ☰

reset

SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762063737	1 Count	41 Count	0 Count
1762061936	0 Count	16 Count	0 Count
1762060135	126 Count	1017 Count	68 Count
1762058335	125 Count	999 Count	68 Count
1762056534	124 Count	980 Count	68 Count
1762054741	119 Count	951 Count	68 Count
1762052940	118 Count	926 Count	68 Count
1762051139	114 Count	895 Count	65 Count
1762049339	113 Count	870 Count	65 Count
1762047538	112 Count	835 Count	65 Count
1762045737	111 Count	811 Count	65 Count
1762043936	110 Count	786 Count	65 Count
1762042136	109 Count	763 Count	65 Count
1762040335	108 Count	733 Count	65 Count
1762038534	107 Count	705 Count	65 Count
1762036734	106 Count	677 Count	65 Count
1762034933	105 Count	658 Count	65 Count
1762033140	100 Count	643 Count	65 Count
1762031339	99 Count	628 Count	65 Count
1762029538	96 Count	611 Count	63 Count
1762027738	95 Count	590 Count	63 Count
1762025937	94 Count	571 Count	63 Count
1762024136	93 Count	557 Count	63 Count
1762022336	92 Count	537 Count	63 Count
1762020535	65 Count	448 Count	37 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)